A00-DRL

DRILLING | T-A® Replaceable Insert Drilling System

4 Series: 46.99 mm - 65.30 mm (1.8500" - 2.5709")

T-A® Drill Holders

Straight Shank Holders

Body

Shank

L 2

L 4

L 3

L 1

L 5

D 2

P 1

Flute

Length

Part No.

A30

22040S-150L 22040S-175L 24040S-150L 24040S-175L 25040S-150L 27040S-150L 29040S-150L

Short Short

4.918 6.500 6.687 10.500 4.000 1-1/2 4.600 6.500 6.687 10.500 4.000 1-3/4 8.918 10.500 10.687 14.500 4.000 1-1/2 8.600 10.500 10.687 14.500 4.000 1-3/4 16.418 18.000 18.187 22.000 4.000 1-1/2 24.418 26.000 26.187 30.000 4.000 1-1/2 34.418 36.000 36.187 40.000 4.000 1-1/2

1/4 NPT 1/4 NPT 1/4 NPT 1/4 NPT 1/4 NPT 1/4 NPT 1/4 NPT

Standard Standard Extended

Straight

XL

3XL

Connection Accessories

Nylon Locking Screws 7514N-IP20-1

Admissible Tightening Torque*

Insert Screws 7514-IP20-1

Insert Driver

8IP-20 1370 N-cm (121.3 in-lbs) *Tightening torques are calculated with a friction coefficient of µ = 0.14 and develop 90% of ultimate yield strength. Refer to Speed and Feed charts for recommended adjustments to speeds and feeds. Refer to page A30: 146 for deep hole drilling guidelines in this section of the catalog. Visit www.alliedmachine.com/DeepHoleGuidelines for the most up-to-date information and procedures. Factory technical assistance is available for your specific applications through our Application Engineering department : appeng@alliedmachine.com. WARNING

A30: 113 - 139

A30: 89 - 91

Key on A30: 2

Screws sold in multiples of 10. = Metric (mm) = Imperial (in)

A30: 95

www.alliedmachine.com | 1.330.343.4283