AMPC-C_EU-EN

REAMING | ALVAN® Reaming Systems by S.C.A.M.I.

TIR Adjustment

A

DRILLING

1

2

B

4 opposite side

3 opposite side

BORING

Step 1: Place the tool into the machine spindle. Make contact with the four radial adjustment screws in a concentric fashion (this results in equal pressure surrounding the tool). Tighten #1, then #3, followed by #2 and #4.

C

Step 2: Swipe the dial indicator around the ground portion of the arbor near the coolant outlet holes to verify the TIR. The TIR should be within 0.0005" (as close to 0 as possible). This will ensure the TIR check on the cutting teeth will be more true. It also means the arbor is running true to the shank. Step 3: Once the TIR is checked on the arbor, check the TIR on the cutting teeth. Rotate the tool counterclockwise to avoid chipping the cutting teeth.

REAMING

Clamping Screw

D

BURNISHING

Step 4: Tighten down the central clamping screws. During the tightening, the tool body will shift slightly. Repeat the TIR check on the cutting teeth and adjust as necessary.

E

THREADING

X

SPECIALS

www.alliedmachine.com | +44 (0) 1384 400 900 | enquiries.eu@alliedmachine.com

C: 77