AMPC_EU-EN

DRILLING | 4TEX® Drill: Indexable Carbide Insert Drilling System

Troubleshooting

A

Starting on Uneven Surfaces • Reduce entry feed by 50% if necessary.

1.

DRILLING

Starting on Angled Surfaces • Reduce entry feed by 20 - 50%. • Use lower rake geometry if insert chipping occurs. Angled Bore Exit • Reduce entry feed by 50% on breakout. • Use tough insert and stable corner radius. Starting on Convex Surfaces • Reduce entry feed by 50%. • Use lower rake geometry if insert chipping occurs.

2.

3.

B

BORING

4.

Drilling Through a Cross Hole • Reduce feed rate 50% if necessary.

5.

• Use good coolant flow and monitor chip packing. • Use lower rake geometry if insert chipping occurs.

C

Drilling on a Groove or Large Centering Box • Reduce entry feed. • Use lower rake geometry for center insert.

REAMING

6.

Chain Drilling • Use good coolant flow. • Reduce feed rate by 50% for interrupted cut. • Use lower rake geometry if insert chipping occurs. Starting on an Edge • Reduce entry feed rate by 50%. • Use lower rake geometry if insert chipping occurs. Starting on a Welded Seam • Reduce entry feed rate by 50%. • Use lower rake geometry if insert chipping occurs.

7.

D

BURNISHING

8.

9.

Drilling Through Stacked Plates • Not recommended.

10.

E

THREADING

Opening an Existing Hole • Use flood coolant.

11.

Adjustable • For mills, use eccentric sleeve with end mill holder. • For lathes, use x-axis to adjust offset Ø. NOTE: Refer to maximum offset Ø in data tables.

12.

X

SPECIALS

www.alliedmachine.com | +44 (0) 1384 400 900 | enquiries.eu@alliedmachine.com

A55: 35