CAT-SET

DRILLING | T-A® Replaceable Insert Drilling System

4 Series: 46.99 mm - 65.30 mm (1.8500" - 2.5709")

T-A® Drill Holders

Straight Shank Holders

Body

Shank

L 2

L 4

L 3

L 1

L 5

D 2

P 1

Flute

Length

Part No.

A30

22040S-150L 22040S-175L 24040S-150L 24040S-175L 25040S-150L 27040S-150L 29040S-150L

Short Short

4.918 6.500 6.687 10.500 4.000 4.600 6.500 6.687 10.500 4.000 8.918 10.500 10.687 14.500 4.000 8.600 10.500 10.687 14.500 4.000 16.418 18.000 18.187 22.000 4.000 24.418 26.000 26.187 30.000 4.000 34.418 36.000 36.187 40.000 4.000

1-1/2 1/4 NPT 1-3/4 1/4 NPT 1-1/2 1/4 NPT 1-3/4 1/4 NPT 1-1/2 1/4 NPT 1-1/2 1/4 NPT 1-1/2 1/4 NPT

Standard Standard Extended

Straight

XL

3XL

Connection Accessories

Nylon Locking Screws 7514N-IP20-1

Admissible Tightening Torque*

Insert Screws 7514-IP20-1

Insert Driver

8IP-20 1370 N-cm (121.3 in-lbs) *Tightening torques are calculated with a friction coefficient of µ = 0.14 and develop 90% of ultimate yield strength. Refer to Speed and Feed charts for recommended adjustments to speeds and feeds. Refer to page A30: 146 for deep hole drilling guidelines in this section of the catalog. Visit www.alliedmachine.com/DeepHoleGuidelines for the most up-to-date information and procedures. Factory technical assistance is available for your specific applications through our Application Engineering department : appeng@alliedmachine.com. WARNING

A30: 113 - 139

A30: 89 - 91

Key on A30: 2

Screws sold in multiples of 10. = Metric ( mm) = Imperial (in)

A30: 95

www.alliedmachine.com | 1.330.343.4283