CAT-SET

DRILLING | GEN3SYS® XT Pro and XT High PenetraƟon Replaceable Insert Drilling System

26 Series: 26.00 mm - 28.99 mm (1.0236" - 1.1416") GEN3SYS XT Pro Holders

A20

Body

Shank

Part No.

L 2

L 4

L 3

L 1

L 5

D 2

Flute

Length

With Flat

Cylindrical

HXT0326S-32FM HXT0326S-32CM HXT0526S-32FM HXT0526S-32CM HXT0726S-32FM HXT0726S-32CM HXT1026S-32FM HXT1026S-32CM HXT1226S-32FM HXT1226S-32CM

3xD 87.0 128.1 130.9 190.9 60.0 32 5xD 144.9 186.1 188.8 248.8 60.0 32 7xD 202.9 244.0 246.8 306.8 60.0 32 10xD 289.9 331.0 333.8 393.8 60.0 32 12xD 347.9 389.0 391.8 451.8 60.0 32 3xD 3.425 5.064 5.174 7.454 2.280 1-1/4 5xD 5.707 7.347 7.457 9.737 2.280 1-1/4 7xD 7.990 9.630 9.740 12.020 2.280 1-1/4 10xD 11.414 13.055 13.165 15.445 2.280 1-1/4 12xD 13.697 15.338 15.448 17.728 2.280 1-1/4

Straight

HXT0326S-125F HXT0526S-125F HXT0726S-125F HXT1026S-125F HXT1226S-125F

HXT0326S-125C HXT0526S-125C HXT0726S-125C HXT1026S-125C HXT1226S-125C

Straight

ConnecƟon Accessories

Nylon Locking Screws 7495N-IP15-1

Preset Torque Hand Driver

Admissible Tightening Torque* 690 N-cm (61.0 in-lbs)

Insert Screws 7495-IP15-1

Insert Driver

Replacement Tips

8IP-15

8IP-15TL

8IP-15B

*Tightening torques are calculated with a fricƟon coefficient of µ = 0.14 and develop 90% of ulƟmate yield strength.

Refer to Speed and Feed charts for recommended adjustments to speeds and feeds. Refer to page A20: 86 for deep hole drilling guidelines in this secƟon of the catalog. Visit www.alliedmachine.com/DeepHoleGuidelines for the most up-to-date informaƟon and procedures. Factory technical assistance is available for your specific applicaƟons through our ApplicaƟon Engineering department : appeng@alliedmachine.com . WARNING

A20: 71 - 86

A20: 7 - 10

Key on A20: 2

Screws sold in mulƟples of 10. = Metric (mm) = Imperial (in)

www.alliedmachine.com | 1.330.343.4283

A20: 58