B10-WHL_EU-EN

BORING | Inserts

Wohlhaupter Insert Geometries Cermet | Carbide

A

B

Cermet | Carbide Geometry

DescripƟon

ApplicaƟon Available Form

• PosiƟve sintered geometry • Special cuƫng edge design in combinaƟon with the chip breaker design enables excepƟonal chip control even at shallow cuƫng depths & light feeds

155

F20, F101, F103, F39

C

F101, F103, F104, F105, F113, F114, F163

158

• Stable sintered geometry for roughing & finishing with & without disconƟnuous cuts

• Wiper geometry for highly producƟve turning & boring • Can be used with pitch angle 92° - 95° • Good chip breaking properƟes even at lower feed rates • Sintered version for a variety of applicaƟons • Low cuƫng pressure because of sharp cuƫng edge prep

174W

F101, F103

D

F39, F101, F103, F104, F112, F113, F163, F161, F262, F264

192

E

F101, F103, F104, F112, F113

• PosiƟve sintered geometry for wide variety of applicaƟons • Special chip breaker allows chip control with different radial depth of cut

199

F39, F101, F103, F104, F264

• Highly posiƟve sintered geometry • Applicable for various material groups for low cuƫng pressure

200

F

• Obliquely ground chip breaker reduces cuƫng forces • Finishing & smooth interrupted cuts

650

F20, F211

• NegaƟve geometry with 0 rake suitable for fine finishing and semi roughing • Machined materials in groups K & H • ConƟnuous and moderately interrupted cut

F101, F103, F104, F113, F163

711

G

• Parallel ground chip breaker • For finish operaƟons with stable cuƫng edge

840

F20

• Parallel ground chip breaker • Good chip control with short to medium feeds

850

F161

H

F101, F103, F104, F105, F325

• Parallel ground chip breaker reduces cuƫng forces • Stable for a wide range of applicaƟons

860

I

J

K

L

M

INDEX

www.alliedmachine.com | +44 (0) 1384 400 900 | enquiries.eu@alliedmachine.com

B10-H: 11