A30-TAS_EU-EN
DRILLING | T-A® Replaceable Insert Drilling System T-A Drill Insert Holders 7 Series | Straight Shank | Diameter Range: 89.10 mm - 101.60 mm (3.508" - 4.507") 7/8
A
L 1
L 7
L 4
DRILLING
D 2
P 1
L 2
L 3
Straight Flute
B
Body
Shank
L 2
L 4
L 3
L 1
D 2
L 7
P 1
Length
Part No.
BORING
22070S-300L 24070S-300L 25070S-300L 27070S-300L 29070S-300L
Short
6.217
8.875
9.125
13.875 17.875 29.000 34.125 44.125
3 3 3 3 3
5.000 5.000 5.000 5.000 5.000
1/2 NPT 1/2 NPT 1/2 NPT 1/2 NPT 1/2 NPT
Standard Extended
10.217 21.342 26.467 36.467
12.875 24.000 29.125 39.125
13.125 24.250 29.375 39.375
XL
3XL
C
REAMING
D
BURNISHING
E
THREADING
ConnecƟon Accessories
Admissible Tightening Torque*
Insert Screws 7619-IP25-1
Nylon Locking Screws
Insert Driver
Replacement Tips
Preset Torque Hand Driver
-
8IP-25
-
-
1750 N-cm (155.0 in-lbs)
*Tightening torques are calculated with a fricƟon coefficient of µ = 0.14 and develop 90% of ulƟmate yield strength.
A30: 102 - 105 Key on A30: 1
X
= Metric (mm) = Imperial (in) Screws sold in quanƟƟes of 10.
SPECIALS
Refer to Speed and Feed charts for recommended adjustments to speeds and feeds. Refer to page A30: 146 for deep hole drilling guidelines in this secƟon of the catalogue. Visit www.alliedmachine.com/DeepHoleGuidelines for the most up-to-date informaƟon and procedures. Factory technical assistance is available for your specific applicaƟons through our ApplicaƟon Engineering Team. WARNING
A30: 108
www.alliedmachine.com | +44 (0) 1384 400 900 | enquiries.eu@alliedmachine.com
Made with FlippingBook - Online Brochure Maker