TG-OVR_US-EN

REAMING | ALVAN® Reaming Systems by S.C.A.M.I.®

Radial Adjusting Shanks Setup Information

XTP TAP TAS HPU APX 4TX REV OPN SSD ACP BTA WHL CRT ALV BRN THM

Radial Adjusting Shanks and Ring Style Arbors The following is a quick guide for setting up a radial adjusting shank and a ring style reamer. The ring reamer arbor does not contain the tang needed to connect to the shank. The tang must first be removed from the shank and then installed into the reamer arbor (demonstrated below).

Step 1: The tang comes installed with the shank. Loosen the clamping screw on each side and remove the tang from the shank.

Step 2: Thread the tang into the back end of the ring arbor. Use a bench vise and wrench to tighten.

Step 3: Assemble the ring arbor to the shank. With the clamping screws still loosened, align the key on the arbor to the keyway on the shank.

Step 4: Once the ring arbor is connected with the shank, tighten the clamping screws to secure the tang back into place.

www.alliedmachine.com | 1.330.343.4283

101