TG-OVR_US-EN

THREADING | Solid Carbide and Indexable Thread Mills

Thread Mill Pre-Drill Information

XTP TAP TAS HPU APX 4TX REV OPN SSD ACP BTA WHL CRT ALV BRN THM

Formula

Metric

Imperial

Velocity

M/min = RPM • 0.003 • Cutter Diameter

SFM = RPM • 0.262 • Cutter Diameter

(M/min • 318.47) Cutter Diameter

(SFM • 3.82) Cutter Diameter

RPM =

Speed

RPM =

Linear Feed Rate (LFR)

mm/min = RPM • (mm/tooth • Number of Flutes)

IPM = RPM • (IPT • Number of Flutes)

(Major Diameter - Cutter Diameter) Major Diameter

Adjusted Feed Rate (AFR) See Note Below

AFR =

• LFR

NOTE: The above formula on an internal thread program adjusts the linear feed rate to be applied to the outer diameter instead of the center of the cutting tool. If the feed rate is not adjusted, the excessive feed rate will cause the thread mill cutting edges to fail.

Example of an Internal Adjusted Feed Rate Calculation:

Free machining steel at 125 BHN with a M16x2 2B thread using ThreadMills USA ™ solid carbide thread mill (TM16200) running at 221 M/min and 0.038 mm/tooth

(M/min • 318.47) Cutter Diameter

(221 • 318.47) 11.94

RPM =

RPM =

STEP 1:

RPM = 5895

STEP 2:

LFR = RPM • (mm/tooth • Number of flutes)

LFR = 5895 • (0.038 • 4)

LFR = 896.04 mm/min

(Major Diameter - Cutter Diameter) Major Diameter

(16.00 - 11.94) 16.00

AFR =

• 896.04

AFR =

• LFR

STEP 3:

AFR = 227.37 mm/min

Unit Definitions

M/min = Meters per Minute SFM = Surface Feet per Minute

Velocity

RPM = Revolutions per Minute

Speed

mm/rev = millimeters per revolution mm/tooth = millimeters per tooth also known as millimeters per flute IPR = Inch per Revolution IPT = Inch per Tooth also known as Inch per Flute mm/min = millimeters per minute IPM = Inches per minute

Feed

www.alliedmachine.com | 1.330.343.4283

119