B10-WHL_EU-EN
BORING | Accessories / Technical InformaƟon
Guidelines for Not Exceeding Recommended Length-to-Diameter RaƟo To calculate, see graphics below:
A
B
62 mm
100 mm 100 mm
100 mm 100 mm 72.5 mm
C
5
6
1
2
3
4
Ø50
Ø50
Ø50 Ø40
Ø50 Ø50
Too many components!
D
NOTE : Length-to-diameter raƟo is calculated using body diameters not cuƫng diameter. NOTE : Do not exceed recommended 10xD length-to-diameter raƟo or exceed four total components (including shank).
E
Step 1: Find L : D by component. 1.2 = 62/50 1
Step 2: Add each L : D average. 1.2 2.0 2.0 2.0 2.0 1.8 + 11.0 = L : D raƟo Too long with too many components!
2.0 = 100/50 2.0 = 100/50 2.0 = 100/50 2.0 = 100/50 1.8 = 72.5/40
2
3
F
4
5 6
G
Alu-Line Components
H
87.5 mm
62 mm
100 mm
1
2
3
I
Ø50
Ø50
Ø50
J
NOTE : Length-to-diameter raƟo is calculated using body diameters not cuƫng diameter. NOTE : Do not exceed recommended 5xD length-to-diameter raƟo when using Alu-Line (Aluminium) components or exceed four total components (including shank).
Step 1: Find L : D by component. 1.2 = 62/50 1
Step 2: Add each L : D average. 1.2 2.0 1.8 + 5.0 = L : D raƟo
K
2.0 = 100/50 1.8 = 87.5/50
2
3
L
Tool failure can cause serious injury. To prevent: -Do not exceed recommended 10xD length-to-diameter raƟo or exceed four total components (including shank). -When using Alu-Line components, do not exceed recommended 5xD length-to-diameter raƟo. -When using tool steel components, do not exceed recommended 6xD length-to-diameter raƟo. -When using heavy metal components, do not exceed recommended 8xD length-to-diameter raƟo. WARNING
M
-When using a carbide shank, do not exceed recommended 9xD length-to-diameter raƟo. -When using a NOVI TECH® module, do not exceed recommended 10xD length-to-diameter raƟo. Factory technical assistance is available for your specific applicaƟons through our ApplicaƟon Engineering department. email: engineering.eu@alliedmachine.com
INDEX
B10-M: 8
www.alliedmachine.com | +44 (0) 1384 400 900 | enquiries.eu@alliedmachine.com
Made with FlippingBook Learn more on our blog